YOUR COMPUTERS. YOUR CONTROL.
Install on another computer
A private connection from this computer. Your SSH keys stay here, and signing in comes separately.
- 1 · Check connection
- 2 · Review & install
- 3 · Connect when ready
Remote computer details
Use a host from this runner’s SSH configuration, or enter user@host. Your existing SSH keys and agent stay on this computer.
Selecting a computer changes nothing remotely. Next, check the connection and review the installation. Existing installations and services on other targets are left alone.
Your connection
- Connecting from
- Loading local runner…
- Remote target
- —
- Install location
- —
- Platform
- —
- Package
- —
Only the selected target will be checked or changed. Choosing another computer clears this review, not its installed software.
Review this installation
- Remote account
- —
- Requirements
- —
- Existing installation
- —
Host identity was checked by system SSH against your trusted configuration. No key was accepted automatically. Installs as the remote account, without sudo. Downloads third-party dependencies. Software installation alone does not sign in or start services.
Package & security details
- SHA-256
- —
- Source revision
- —
SSH key/agent selection follows your local SSH configuration. Agent forwarding and connection sharing are disabled. New host keys require explicit fingerprint verification here. Changed keys are blocked and must be resolved in your SSH configuration.
Ready to check
Nothing has been changed on the remote computer.
Connection diagnostics
- Action
- Outcome
- Last observed stage
- Started
- Elapsed
Measured by this runner for the latest action, including network and approval waits. A completed action does not establish application readiness. No raw remote output or credentials are retained here.
SSH host fingerprint
- Host presented by SSH
- Key type
- Fingerprint
Compare this fingerprint with the one supplied by the computer’s administrator or its trusted hosting console. Do not rely on the connection you are verifying.
Confirming lets OpenSSH save this key in this runner’s existing known-hosts configuration. It does not install software, sign in to HiveCast or approve enrollment. If it does not match, cancel setup.
Approve on your HiveCast platform
Sign in there, review the account and device, and check that this code matches. Your password and approval stay on that platform.
Open sign-in & approvalReturn here after approval. Keep this runner open while the remote computer saves enrollment and starts its service.
Software installed. Connect when you’re ready.
Connect now requests approval on the selected platform, then starts this installation’s background HiveDock service. Nothing is approved automatically. Finish for now by closing the runner, or use this retained command later:
The installed files remain on the remote computer when you close this page or disconnect SSH.
Connection setup finished
The installer completed enrollment and background-service setup. This is not yet a check that every runtime or application is ready. Open HiveCast to find this installation, or inspect its status on the remote computer.
Open HiveCastClosing this runner does not stop the independently managed service.
This installation’s runtime
- Enrollment
- Installation
- Supervisor
- Runtimes
- Background service
- Checked
This is a read-only observation from the remote installation, not an app test or a new approval. Match this exact installation in HiveCast when choosing where to install an app. A stopped or partial setup needs recovery, not a new pairing.